HKPRO Forums banner

How to temporarily remove control lever on HK45?

2105 Views 3 Replies 4 Participants Last post by  bones0831
Is there any easy/short way to remove the control lever on a V1 HK45 temporarily? I need to sand the back of the lever a little as it's scrapping up the frame's plastic, but am hesitant with removing lots of little pieces to do it. I'm hoping I can just pull it out and push it back in after; kind of how removal of the slide release lever is.

Thanks!
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top