[Tulse]

I have the pusher for the USP, but we all know that won't work with tall sights.

Does anyone know if the KSP Uni-200L (universal pusher) will work with Straight Eights and work with the stock sights on a P30?

Or is there another pusher out there that works?

Thanks.

 

[gtmtnbiker98]

More than likely they will require some form of fitting. You'd be far better off sending your slide to Heinie for them to fit and install.

 

[Tulse]

Yea, I've heard and seen the fitting warnings, too. My issue is I need them off one P30 and onto another. I guess Heinie will get both slides.

Thanks,

 

[M_E_]

I have all sorts of pushers including universal ones. None of them would work on the P30. So, I got out my vice, 1/4 " thick leather pad to wrap the slide. Use a brass punch to remove the factory sights & a nylon one to install the Heines. BUT, you WILL need to fit the Heines to the slide. Some fine sand paper to take them down to fit into the dovetail. Sand the bottoms until you can START them in 1/4 of the way in. Cold blue the sights bases & use the nylon punch to put them in. Take a dremmel with a drum or wheel to sand down the set screws to the proper length. Put them on an allen key to hold them. Test fit until they fit flush. Cold blue & install them.

DONE

 

[HKOREGUN]

More than likely they will require some form of fitting. You'd be far better off sending your slide to Heinie for them to fit and install.

Couldn't have said better myself

 

[Brownie]

More than likely they will require some form of fitting. You'd be far better off sending your slide to Heinie for them to fit and install.

I agree 100%.

I did a set myself on a P30 that I got used. What a pain in the butt. I got them in but they ended up being a lot tighter than they needed to be. If I had it to do again I wouldn't even hesitate to send them in.

 

[DaZe831]

Send it in so they can for them on right. Get the max performance for your money. Might as well get good sights dialed in right