HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
right now when the slide is all the way forward, i can still see a bit of brass in the chamber. it's like the slide and the barrel aren't perfectly flush so it creates a small opening where i can still see the brass.

thoughts? should i worry?
 

·
Registered
Joined
·
818 Posts
What is the guns caliber?
 

·
Premium Member
Joined
·
1,843 Posts
On both of my P2000's, with a loaded chamber, I can see a small section of brass in the area around the extractor claw... never really thought about it before I saw this thread. Thousands of rounds through them without any problem.
 

·
Registered
Joined
·
765 Posts
If you're seeing it from the top of the slide, you may have problems. through the side is normal.

A good test, is to remove the barrel, and drop a round into the chamber without the rest of the weapon involved. If the round doesn't drop down to at least flush with the top of the hood, then your ammunition may be a tad too long (usually this becomes apparent with feeding issues, though).
 
1 - 5 of 5 Posts
Top