HKPRO Forums banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
1,326 Posts
Discussion Starter #1
Is it possible and if so what parts are needed to convert USP 10 round mags to 12 round.
 

·
Registered
Joined
·
18,641 Posts
No, unfortunately, it is not possible. IIRC, a member has used opoxy (or JB Weld) to seal the holes on the side of the mag housing and bend the lips on the bottom of the housing to accept a 12-rd mag floor plate but it is much easier trading the 10 for 12, or sell and buy one.
 

·
Premium Member
Joined
·
1,326 Posts
Discussion Starter #3
No, unfortunately, it is not possible. IIRC, a member has used opoxy (or JB Weld) to seal the holes on the side of the mag housing and bend the lips on the bottom of the housing to accept a 12-rd mag floor plate but it is much easier trading the 10 for 12, or sell and buy one.
I had a feeling that would be the case. Thank you sir.
 
1 - 3 of 3 Posts
Top