HKPRO Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I just picked up a JLD PTR-91KFM4 seriel# A4xxx range and will be sending in the papers to sbr it to g3k length.
I have a few questions about going about it.

1. should I have the original barrel cut down or a new RCM one installed.

2. can I have the information on the left side of the rifle tig'ed and remarked? It just says JLD PTR-91 and the has that stupid scorpion stamping.
all of the manufacture information is on the right mag well.

3. did G3K rifles have a gernade ring?


Thanks,

Brian
KE4CXP
 

·
Registered
Joined
·
346 Posts
1) If you have a good barrel, it would save you some cash to have it cut down. Arizona Response does them.
2) Not a good answer but I think it's okay.
3) Yes, they have grenade rings.
 

·
Registered
Joined
·
17 Posts
Discussion Starter #4
Thanks for the replys. I got out and shot the JLD today and was pretty impressed as it ate the last 140 rounds of South African ammo I had.
I will have to look into Arizona Response once the form 1 comes back.
 
1 - 4 of 4 Posts
Top