HKPRO Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter · #1 ·
About a week ago there was a thread... talked about removing powder coat or epoxy finish. There was a link to a product that did that.
Anyone help?
 

·
Registered
Joined
·
425 Posts
Epoxy...

On epoxy, I use glass bead. It will clog your recovery system on the blast system fast so watch your levels. Medium coarse on the beading material will ensure little damage to the engraving and edge detail and still dispatch the coating in a timely manner.
P.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top