HKPRO Forums banner

Magpul angled foregrip specifically for the G36 Handguard without picatinny required?

665 2
I saw a photo of a G36 somewhere which had a Magpul angled foregrip attached directly to the G36 handguard without a picatinny rail on it. It was close to the magwell...

I haven't been able to locate this exact model; does anyone know where one of these can be purchased?
1 - 1 of 1 Posts

· Registered
Joined
·
154 Posts
I bet it's not too difficult to Dremel out some grooves that are the same shape as the M-Lok rectangles, or at least the same size where the screws and locking tabs could fit. That should put the AFG flush with the bottom of the handguard.

Image from their website:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top