HKPRO Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
232 Posts
Discussion Starter #1
I've read alot of talk about it suppose to work, or someone said it would. Does anyone KNOW that the MGW Sight adjust/install tool - H&K USP, P2000
sight tool will work on a 45c.
 

·
Registered
Joined
·
18,641 Posts
Yes, it works. That's what I use to install Meps and Trijicons on my HK45 and HK45C (also P30/P30L/P2000/P2000SK). Just remove the shim for HK45/HK45C/P30/P2000/P2000SK.
 

·
Registered
Joined
·
232 Posts
Discussion Starter #3
Where's the shim located? Or will it be an easy see?
 

·
Registered
Joined
·
232 Posts
Discussion Starter #5
I know this is late but does that sight pusher work on the front sight as well?
Thanks so much for your help.
Erich



Bottom of the pusher (in red in the below pic).


Photo courtesy of HKParts.
 

·
Registered
Joined
·
18,641 Posts
Yes, works on HK factory, Ameriglo, Meps and Trijicon front sights as well, except the tall sights (Tactical, Novak).
 

·
Registered
Joined
·
232 Posts
Discussion Starter #8
XS included in that. I don't believe XS's are tall.

Yes, works on HK factory, Ameriglo, Meps and Trijicon front sights as well, except the tall sights (Tactical, Novak).
 

·
Registered
Joined
·
18,641 Posts
TooSixy,

The front slide of the USP is not flat. Will this sight tool able to hold the slide firm?
Yes. There is no wobbling with the slide. In fact, USP is engraved on the sight pusher itself. :wink:
Just make sure the slide is perpendicular to the sight pusher.
 
1 - 9 of 9 Posts
Top