HKPRO Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,720 Posts
Discussion Starter · #1 ·
I'm trying to send to a smith to convert MKE AT94 w/ mag block & stock to full MP5 spec (w/o sear capability of course...).
How much should I expect to pay to perform following works? I'm already filed a form-1 w/ ATF (say 6 mts now days? LOL).
  • Cut barrel & 3 lug adapter install
  • remove 10rds block bar (I'm aware of the compliance laws w/ domestic parts count)
  • Minor touch up on barrel chop off area & mag area where blocking bars were presented.
Anyone done it before?
Who has good price on this type of conversion and how much to pay?

thanks in advance.
 

·
Registered
Joined
·
3,337 Posts
I'm trying to send to a smith to convert MKE AT94 w/ mag block & stock to full MP5 spec (w/o sear capability of course...).
How much should I expect to pay to perform following works? I'm already filed a form-1 w/ ATF (say 6 mts now days? LOL).
  • Cut barrel & 3 lug adapter install
  • remove 10rds block bar (I'm aware of the compliance laws w/ domestic parts count)
  • Minor touch up on barrel chop off area & mag area where blocking bars were presented.
Anyone done it before?
Who has good price on this type of conversion and how much to pay?

thanks in advance.
How do I find him I am new here. Thanks.

Call Jeff at AZARMORY at 602-819-4615 he can do it for as he did both of mine as you describe.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top