HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
HI new guy here. Got a hk4 and after configuring to .22 ,the safety will not go to fire. If i put the firing pin in the centerfire position it will go to fire . Any suggestions?
 

·
Registered
Joined
·
1,690 Posts
You either have the firing pin upside down, or the two detents/spring that hold in the extractor are either not in correctly, or are installed in the wrong order. Make sure the safety is in the middle position first, then moving towards the extractor, then you have a detent, a spring, and then another detent. Then the extractor. It should all slide into place then.

That should work, dad. :p

See: Part #3, #4, then #3
 
1 - 3 of 3 Posts
Top