HKPRO Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi, I need to switch out my sear and trigger pack from one housing to a new housing I just got in the mail yesterday. I've been trying to get into an HK armorer's class for a while now but the one that I signed up for was cancelled due to not enough interest.

So, is there a weblink with step-by-step pictorial instructions on moving everything out of one lower to another? I am much more familiar with ARs right now than HK 9x series, so any help is appreciated.

Thanks.
 

·
Registered
Joined
·
340 Posts
Is it a SEF pack or a Ambi group? If it is the ambi then the sticky on this page will explain it, here is a link:

http://hkpro.com/forum/showthread.php?t=58552

If it is an SEF all you do is rotate the selector upwards past the "S" position until the selector lever is pointing upwards perpendicular to the group housing and then pull it out. Once the lever is removed all you have to do is pull up on the entire trigger pack and it will slide out of the housing.

Hope that helps and makes sense.
 
1 - 2 of 2 Posts
Top