HKPRO Forums banner

·
Registered
Joined
·
279 Posts
Discussion Starter #4
Need a version that has bolt gaps for all the 9x series guns!
Send me the stats (link me the manual) and I'll make you one bud! I like going off the manual. That MP5 one was based off their own overpriced gauge (.1/.5mm) and the manual with the optimal range.
 

·
Registered
Joined
·
279 Posts
Discussion Starter #7
Can someone send me the stats of the 9x series guns? I would like a page from the manual so I can have "official data" and I don't engrave the wrong stuff.
 

·
Premium Member
Joined
·
195 Posts
Send me the stats (link me the manual) and I'll make you one bud! I like going off the manual. That MP5 one was based off their own overpriced gauge (.1/.5mm) and the manual with the optimal range.
The mp5 spec is 0.25-0.45mm (ideal), 0.25-0.50mm (maximum), or .010" -.018" ideal/max if using imperial measurement

.004" is too low, and it should ideally be at the high end of the spec initially
 

·
Registered
Joined
·
279 Posts
Discussion Starter #10
The mp5 spec is 0.25-0.45mm (ideal), 0.25-0.50mm (maximum), or .010" -.018" ideal/max if using imperial measurement

.004" is too low, and it should ideally be at the high end of the spec initially
I went off the original HK go/nogo gauge which is .10mm and .50mm (I copied those numbers) and put the ideal range from the manual.

 

·
Registered
Joined
·
279 Posts
Discussion Starter #12
ok, I can make those changes. I think it better reflects the correct numbers.

 

·
Registered
Joined
·
279 Posts
Discussion Starter #13
I went off the original HK go/nogo gauge which is .10mm and .50mm (I copied those numbers) and put the ideal range from the manual.

I've made the change. 0.50mm in inches is 0.0196" so I will leave it at .020"... 0.018 is incorrect which would be 0.0177" rounded to .018"
 
1 - 15 of 15 Posts
Top