HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1
I have a Fleaming H sear in transfer and just ordered a Cohaire .40 pistol. Will a 9mm lower fit on these or do I need a .40 with the bolt hold open relief for this?

If I need a .40 housing for this can I just swap the pack from a .9mm or are tehy different?

Are the Cohaire clone A3 stocks any good or do I have to spend $500 on a real HK?

Thanks Russ
 

·
Registered
Joined
·
670 Posts
I believe there are differences in the hammer spring, and ejector between the 9mm and .40 lowers. If you already have a 9mm lower you can just find the .40 parts and swap them out. A good source is Adam Webber http://www.hkparts.net/510.htm

The Clone will still offer the BHO device and the lower will need the cut for that device to fit.
 

·
Registered
Joined
·
162 Posts
russ,

no offense intended, but you just dropped over 12k on a sear, i would not use a clone a3 stock, as they do not lock up tightly.

buy the german F stock with the cutout. you can pick them up for under 400 bucks form www.hkparts.net or www.hkspecialist.net


eta: reference to the old junk a3 clones from gunbroker. no ideas on TB's new a3 clone stocks.
 
1 - 3 of 3 Posts
Top