HKPRO Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter · #1 ·
Just wanted to say thanks to those of you who have posted tips and how-to's about this. I've got a clone with some bolt gap issues and decided to press out and re-install the barrel myself. After a quick search, i noticed that most questions about how to do this were answered by "Go pay someone else to do it." I like to learn how to do things myself and followed some of the instructions on here. The whole job took about two hours but I went pretty slow. Just hammered the pin back in this morning and i've got a nice gap of .019/.020 with standard rollers (used to be .035 with -6 rollers!). I figure on losing a thousanth or so after firing and sitting perfectly on proper headspace.

Thanks again for taking the time to post.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top