HKPRO Forums banner

1 - 16 of 16 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter #1
Took the MP540-SD out for a spin yesterday. First mag worked perfect. Second mag started jamming during 2-3 round bursts. Possible fail to extract issue. Really mashed up the shell casing of the spent round and compressed the bullet of the new round about halfway into the casing. Odd failure. Any ideas? Hope to strip it down later today.
 

·
Registered
Joined
·
215 Posts
Or a dirty gun, or a new gun that's not broken in, or ...
 

·
Registered
Joined
·
215 Posts
I'm getting subtle clues that this may be more than an ejector spring problem.
 

·
Merchant of Death (Admin)
Joined
·
11,851 Posts
Definitely a matter integration/disintegration/reintegration issue.
 

·
H&K Certified Armorer
Joined
·
8,216 Posts

·
Merchant of Death (Admin)
Joined
·
11,851 Posts
In the midst of caffeination and it was stream of consciousness... It worked, then it broke, then it needed to be fixed.
 

·
Registered
Joined
·
155 Posts
Discussion Starter #14
When I pulled the bolt out; that is what I found. Exactly. No extractor or pin. No idea where it went other than it something broke and it got spit out with some brass. Never seen this happen before. Any ideas?
 

·
Merchant of Death (Admin)
Joined
·
11,851 Posts
Okay, now my comments make sense! Integration... disintegration... It was there and then it wasn't. You obviously created rip in the space/time continuum.
 
1 - 16 of 16 Posts
Top