HKPRO Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I'm looking to get a bigger bolt catch on my MR 762 - G28 build. I was thinking of getting a Magpul Bad lever and cutting it down. Any better suggestions? I really want it to look nice.... are the G28 ones coming to the states? Thanks, Mark
 

·
Registered
Joined
·
434 Posts
Does anyone know if this will in fact fit on a MR762? Any pictures of an installation? Clarification - I am looking for a "BAD" type ambi lever for a MR762.
 

·
Premium Member
Joined
·
3,438 Posts
Does anyone know if this will in fact fit on a MR762? Any pictures of an installation? Clarification - I am looking for a "BAD" type ambi lever for a MR762.
As it replaces the original it should fit. You can't use an actual BAD on these because there is no space between the receiver and back of the release button unlike the 556.

But no, I haven't seen it installed.

DPMS makes a replacement lever as well for AR10 type rifles. It has an extended release lever on it but it's not ambi like the a BAD and I can't actually find it on their website. But there are uTube vids of its installation.
 
1 - 5 of 5 Posts
Top