HKPRO Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Have any of you taken off the new HKey handguard? I'm wondering about the the tool you've used...

I went to a local hardware store and they didn't seem to have a flat end screwdriver that was big enough. I may need to try a more specialized tool shop tomorrow.
 

·
Registered
Joined
·
700 Posts
They are made to be opened with a metric 11mm.

SW11 on it literally means "Schlüsselweite 11", which means Wrechnwidth 11. So dont get a screndriver but order a metric 11 wrench or bit.
 

·
Registered
Joined
·
24 Posts
Discussion Starter #3
Thank you baljar!

I suspected that there must be an exact tool for the job, but didn't know what kind. I also checked the manual, but all it shows is how to take apart the older version with the quadrail.
 

·
Registered
Joined
·
551 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #6
I had one at home and it worked perfectly. I must be blind, as I was seeing that it was just a screw, that needs a big flat end screwdriver, and not a bolt... I felt quite smart when I started looking at it more closely and immediately noticed what it was...

Thank you for pointing it out to me!
 
1 - 6 of 6 Posts
Top