HKPRO Forums banner

MR556 / HK 416 Sear Gun - Video

5702 16
Well, I finally got to shoot my HK-416 Clone today with my newly approved JCB RDIAS installed. Here is a pic of the gun:


It is an MR556 Lower with HK-416 Upper and HK416 LPK. It runs like a top.
G36K Conversion :: ShootingHK416Clone3-24-12.mp4 video by vette447 - Photobucket
1 - 17 of 17 Posts

· Registered
Joined
·
99 Posts
Any chance we could get a shot looking down into that lower? I'd love to see how the RDIAS is installed. I'm guessing at least a little milling around in the lower right? That was an MR556 lower with some engraving work done right?

Damn nice clone!
 

· Registered
Joined
·
276 Posts
Discussion Starter · #6 ·
The lower is bone stock. No milling required. The lug on the upper is a bit fatter than spec though and I had to take a few thousandths off of the front of the lug so the RDIAS would fit on it. RDIAS works great with minimal fitting and no tuning.
 

· Registered
Joined
·
331 Posts
Very nice!! But I could buy a lot of other toys for 11K....and more ammo!!:100000:
 

· Vendor
Joined
·
7,526 Posts
Very nice! When I saw the pic of it the other day I thought you got your hands on dealer sample.
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top