Hi all first post here, I recently acquired an MR556a1 and have decided on going the LPVO route. My top contenders at this point are the Vortex razor 1-10 and eotech vudu 1-10. I was wondering if anyone here had a similar setup to this main focus for me is what mount to go with given the HK’s taller receiver. Thanks in advance.
P35fan
Joined
·
807 Posts
Joined
·
807 Posts
Yes 34 mm with an insert then I found material to make up the 1mm difference on the front. I'll have to go back and look which brand insert I used and where I got the material from the front for. I tried a few different options and to be honest can't remember what finally worked best. If I remember it was crappy magnet paper that they do those refrigerator magent business cards from. It's been a while. I can find it though. I'll try to remember to do it tonight.
Joined
·
807 Posts
Hey I'm sorry I forgot to reply back.
So for the 34mm to 30mm ring I used this:
for the 34mm to 33mm ring I found a site that had rubber and silicone materials that would do the job and were the right thickness but at the end of the day still ended up being just a hair too think. So I'm looking around my desk at work (I work in printing) and there are these very low power magnet papers we print on. They barely work as a magnet so these samples are just lying there not being used and I start thinking this is about the right thickness and the material should have enough grab to it so the sight doesn't move. I tried that and it was perfect. I've been to the range a few times with it and haven't noticed any movement or shift of zero issues. I've also heard of people using the material from aluminum cans effectively. Apparently this is an old scope mounting trick.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
