HKPRO Forums banner
1 - 4 of 4 Posts

4 Posts
Discussion Starter · #1 ·
Hello and please help. I did search the site but couldn’t find an answer to:

my safety selector switch is a bit loose. I think there are Allen screws holding the switch in but I am not sure.
What is the fastener holding the switch on?
What size Allen wrench is it-if it is an Allen type.
Is it supposed to flip about 1/8” side-to-side?
Picture for clarity:
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.