HKPRO Forums banner
1 - 1 of 8 Posts

· Registered
Joined
·
938 Posts
So I recently got an Elcan M145 MGO to go on top of my G3. This scope was intended for the US M240, and I have it sitting on a low-profile B&T rail on the G3. As you can see from the pictures, I have the scope as far back as I can get it before the rear diopter stops it. This is workable, but I would really like to get it back another inch or so to make my cheek weld with that PRS stock work nicely, and I can only do this by removing the rear sight. That of course leaves me without irons. I've looked around for any possible flip-up type sites that will fit in the HK rear-site fitting, but have found nothing. Ideas, anyone?

Get rid of the Canadian and get a Hensoldt.

Snackbar Cat

https://www.youtube.com/watch?v=xRZw6Duh6MQ


This message brought to you by beer.
 
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top