HKPRO Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
106 Posts
Discussion Starter · #1 ·
there are two spring clips that each hold a push rod on the merkel / hk between the bolt carrier and the block the piston pushes against.

i found them in the german manual 15 SL-Sicherung 986551. Need to know if I can get them... or if you know the dimensions for a common spring clip that would work
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top