HKPRO Forums banner

Needed: A few pictures of the USC trigger group, in detail!

1421 Views 3 Replies 3 Participants Last post by  DarkPhoenix
So I began my USC -> Grease Gun conversion. And am putting the trigger group back together in the GG lower. Problem is, I didn't take enough pics of the area I'm having an issue with. The pictures in the instructions are absolutely horrid. I'm currently messing with the rear pin area where the two smaller springs need to be finagled somehow. Can anyone take a few pics of that area for me? Preferrably higher res and clear w/ good lighting. Any more pics you could take as well would be appreciated! Thanks in advance!

Signed,
Guy who only messes w/ AR15s usually.
1 - 4 of 4 Posts

· Registered
Joined
·
30 Posts
Discussion Starter · #3 ·
THANK YOU!

Very much needed and has the area I needed more clarification on.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top