HKPRO Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I took apart my non-HK bi-pod and noticed that I could rotate the pin located in the top of each leg 180 degrees so that the other side fits inside the groove/notch of the upper section to hold the leg in the down position. I was thinking that maybe I could make another piece to fit in the groove/notch better and thus improve the wobble and non-locking legs. As it is now the legs are usless for shooting. If this does not work I may install a sling stud and go the harris bi-pod route.
 
1 - 1 of 1 Posts
Top