HKPRO Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I took the screw out of each side of the grips, but they won't budge. What is the correct way to remove the facory panels ? Thanks
 

·
Registered
Joined
·
85 Posts
Take the magazine out, with the grip screw off, stick your finger in the mag well and gently push up the grip panel. Grasp the square corner of the grip and wiggle the grip. It has a small lip on the backside of the grip. Be careful and do not break them.
 

·
Registered
Joined
·
802 Posts
Or just pry a little off the front side of the grip above the trigger guard. That's what needs to clear before the grip can slide forward.
 

·
Registered
Joined
·
2,783 Posts
Take the slide off first. There is a ledge at the top of the grip that goes up under the slide. If you don't remove the slide it is a bi-otch to get off without damaging the grip panel.
 
1 - 4 of 4 Posts
Top