HKPRO Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter #1 (Edited)
I have sort of a general information question that is probably an easy one for you guys that have multiple HK pistols.

Are the P2000 and P30 slides the same height from where they meet the frame to the top surface of the slide or is one taller than the other. They look to be the same height but I figure somebody knows for sure.

I know the P30 slide is slightly longer by about 4mm or so and the total height of the P30 is greater than that of the P2000. However the photos sort of make me think the difference in total height is in the frame/mag/grip as opposed to being in the height of the slides.
 

·
Registered
Joined
·
69 Posts
Discussion Starter #4
Sorry....I did not notice I had typed P3 until you mentioned it. Went back in and edited the post for the corrections. Not even really sure how I did that as I have been typing P30 into this forum for a few days now. Just plain got distracted.
 

·
Registered
Joined
·
69 Posts
Discussion Starter #6
Thanks TooSixy. Sorry again for the screw up guys.....thanks for the correction.
 

·
Registered
Joined
·
1,785 Posts
I pretty sure they're the same height slide. Wasn't there an HKPRO member around here who actually fired his P2000 with a P30 slide?
 

·
Registered
Joined
·
1,053 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter #10
Thanks very much for the responses guys. This IS the best brand specific firearms forum on the Internet. As usual the members make it that way. Will likely be a while before I can contribute at anything like the value level that you guys represent.
 
1 - 10 of 10 Posts
Top