HKPRO Forums banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
496 Posts
Discussion Starter · #1 ·
A couple of issues came up and I need feedback:

My hammer spring shows finish wear in a line that faces the magazine well. It appears that the magazine comes into contact with the spring through the rectangular cut in the well. Any issues?

Also, in regards to the pin that is used to secure the grip panel. Under reasonable care, should I have any problems with an enlarged hole due to multiple grip changes?
 

·
Registered
Joined
·
3,465 Posts
1. No.
2. No.

Hope it helps! :D
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top