HKPRO Forums banner

P2000sk slings brass?

1073 Views 9 Replies 6 Participants Last post by  amstaffHK
My "new" p2000sk (40 smith, looks pretty well used, not as advertised by any means) slings brass about twice as far as the newer P30L, so I'm just wondering.... No failure to feed, fire, or eject and this is with the Winchester 180 grain HP ranger load. Is this "normal" and what I can expect? Is the replacement spring on HK Parts the same spring for the 9mm, 40 & 357 Sig? Love the weapon, but it is slinging the brass quite a way at the range. Thanks in advance, tim

P.S. No, you can't have it to "help" me with my question...
1 - 1 of 1 Posts

· Registered
Joined
·
3,592 Posts
All P2000SK pistols use the same recoil spring assembly regardless of caliber, the spring is always painted red although it wears/flakes off rather quickly. There is only a single part identification number for the P2000SK recoil spring assembly for the 9mm, .40S&W, and .357SIG (#207119).

Strong positive ejection is not a flaw in a service pistol, it is in fact a desired trait.
Good info right there ^

With the p2ksk using a universal assembly for 9mm,.40/357sig along with it being a low mass slide it's going to sling it regardless IMO. Don't be disapointed when you put a new assembly in and don't notice any immediate difference, not to say you won't but I'm putting my money on no difference if so very minimal.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top