HKPRO Forums banner

P2000sk slings brass?

1074 Views 9 Replies 6 Participants Last post by  amstaffHK
My "new" p2000sk (40 smith, looks pretty well used, not as advertised by any means) slings brass about twice as far as the newer P30L, so I'm just wondering.... No failure to feed, fire, or eject and this is with the Winchester 180 grain HP ranger load. Is this "normal" and what I can expect? Is the replacement spring on HK Parts the same spring for the 9mm, 40 & 357 Sig? Love the weapon, but it is slinging the brass quite a way at the range. Thanks in advance, tim

P.S. No, you can't have it to "help" me with my question...
1 - 3 of 3 Posts

· Registered
Joined
·
376 Posts
Discussion Starter · #4 ·
Chuck, thanks. I've just ordered the new assembly. Wondering if "one size fits all" is correct as there's only one listed. Seems to me the 9mm would be a bit less recoil than the 40 with 180 grain loads?
 

· Registered
Joined
·
376 Posts
Discussion Starter · #6 · (Edited)
Just looked at the springs. The smaller (inner) spring is, in fact, red on my sk. The larger spring doesn't really have a color code that I can see, so I'll just have to wait and see what's there on the new assembly. I will report back, once I've range tested the new assembly. Thanks, tim

P.S. I've just contacted HK Parts about the springs, so I should have an answer soon. Will post as soon as I can.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top