[Wolvee]

What are my options for my SK in terms of suppressor sights?

Do P30 or P2k sights work? HKParts has a very limited selection of any sights at all for the SK suppressed or not.

 

[chester]

How would you be adding a suppressor to the SK?

 

[Wolvee]

With money. ...but that's not what I need them for.

 

[chuck s]

OK, just what do you need them for? There may be alternatives folks can suggest.

Heinie makes tall sights for the HK45C/P30 (same dovetails). Not sure they'll fit the P2000SK.

-- Chuck

 

[RyanW]

I'm going out on a limb and assuming you want them to cowitness??? If so, send me a pm.

 

[PhilCam]

I don't think the P2000 series share the same dovetail cut as the USP. It's unfortunate, because the only night sights I can find for my SK is the Meprolights and Trijicons.

 

[majette]

try this, use the stock sights and consider the suppressor outline as part of the target. bullet goes where the center dot covers. no problem for me shooting center mass 25yds and closer the few times i have used a can.

 

[Wolvee]

Thanks but that's not what I need.

 

[chuck s]

OK, don't tell us! :wink:

-- Chuck

 

[RHINOWSO]

It's a secret mission requirement, he could tell us, but then he'd have to kill us...

 

[Wolvee]

lol, yes i need them to co-witness.

 

[chuck s]

Co-witness? There's only one set of sights. You need two different sights to "co-witness."

-- Chuck

 

[Wolvee]

Now you're catching on, lol.

 

[bzdog]

Sounds like he is looking into adding a mini red dot sight like Mark H. recently did on a P30.

-john

 

[Wolvee]

I've been in contact with Housel and a few others trying to get this done. Housel brought up a point that he only knows of one sight that is not discontinued that works on the P30. This poses a problem that I had not thought about. The P2kSK doesn't have any sights worth crap (that i've found) that could work. The basic cost of new engineering isn't that big of a deal but something small like this can skyrocket the cost. I'm really happy with a G26 & RMR combo so if this gets to the point of diminishing returns I'm just going to nix the idea all together.

I really want to have it done to the HK but as everything it comes down to "Dollars and Sense".

 

[bzdog]

It seems like it wouldn't be overly hard to fabricate a front supressor sight -- just cut the top off the stock sight, braze a supressor sight on, and re-finish it.

Considering how short the SK is, it might be better to epoxy something(s) to act as a rear notch directly to the RDS as opposed to mounting a RBIS.

-john