HKPRO Forums banner

P30 9mm DA/SA to LEM Conversion

3974 Views 13 Replies 6 Participants Last post by  TGS
Ok I have one P30 9mm and another one on the way to me for my second one. I have looking around the site and could have sworn I read a post about changing the P30 with the DA/SA trigger set up over to the LEM trigger. I have also been looking to see which kit I would need to be able to do this as I remeber seeing in the thread I read that it could be done but the place where the decocker sits on the rear of the frame would have a little open slot.

Who here has done this conversion and how long or hard was it do it? I can build AR15's and trip down SIG's for the most part and work on them. Is the H&K a little bit harder to do? Also does anyone know if there are any H&K armors around KY? If I had to I would get the parts kit's for the conversions and then just take the guns over the the armor and have them do it for me.
1 - 3 of 3 Posts

· Registered
Joined
·
1,883 Posts
I've done it. It's no harder than any other LEM conversion. From your experience I don't think you'll have a problem. This is where I tell you that the P-series is unique in the fact that, due to the frame differences, HK doesn't support or condone variant changes as they do with the other models. If you could find an armorer (which is easier said than done) they might not do it for you for the above reason.
 

· Registered
Joined
·
1,883 Posts
Thanks I am just a little worried about doing anything with the H&K, again working and building AR15's and working on SIG's and Glocks is a litte easier. I have never worked on an H&K and would be scared I would mess something up and not be able to fix it on my end.. I called H&K USA and asked about me sending the pistols into them to have it done, I almost fell out of my chair when they told me how much it would be for just one. it would have ended up costing almost $300.00 just to have them one then the same amount for the second one, I am looking for a really good armor or an H&K armor around here in KY that could do it for me if I ordered the parts kit.
There's nothing to screw up. If you follow the instructions in the reference section it's really very simple. As far as calling HK......you're saying that you called HK and time them that you had a V3 P30 and that you wanted them to convert it to LEM and they told you that they would do it and it would cost $300? Based on their stance in the past this doesn't sound right.
 

· Registered
Joined
·
1,883 Posts
Hmm, interesting. Need more confirmation on this, be great news if we can now "officially" convert P30/L V3 to V1/2 without voiding warranty now.
I wouldn't get excited just yet. My money would be on the fact that whoever was talked to at HK missed that it was for a P30 and was basing his info accordingly. I find it very hard to believe that HK is blessing such a conversion.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top