P30 9mm DA/SA to LEM Conversion

3974 Views 13 Replies 6 Participants Last post by TGS, Feb 12, 2012

Ghost_6

Discussion Starter · #1 · Feb 11, 2012

Ok I have one P30 9mm and another one on the way to me for my second one. I have looking around the site and could have sworn I read a post about changing the P30 with the DA/SA trigger set up over to the LEM trigger. I have also been looking to see which kit I would need to be able to do this as I remeber seeing in the thread I read that it could be done but the place where the decocker sits on the rear of the frame would have a little open slot.

Who here has done this conversion and how long or hard was it do it? I can build AR15's and trip down SIG's for the most part and work on them. Is the H&K a little bit harder to do? Also does anyone know if there are any H&K armors around KY? If I had to I would get the parts kit's for the conversions and then just take the guns over the the armor and have them do it for me.

Save

Reply Quote

1 - 1 of 1 Posts

HKfaninMD

· Registered

Joined Apr 24, 2011

731 Posts

#8 · Feb 11, 2012

There is a really good LEM conversion video a member posted here recently on an HK45c. Along with Big Bore's guide (see reference section), you should have no problems. And if you do, just hop back on this forum and tell us what the problem is and someone will walk you through it. I am also surprised HK is doing conversions on P30's -- I thought they didn't do those because of the gap left from removing the decocker. Good luck!