HKPRO Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I want to replace my slide stop levers to shorter ones. Will the HK P30S & HK P30LS Slide Release fit on the lem pistols without any issues. How do you get the old levers out? Thank you.
 

·
Registered
Joined
·
18,646 Posts
The lever on the P30S is shorter and will fit your P30. One of the members had done this swap on his P30. It might have been NCDevilDog but I am not sure.

To remove the lever, push it out from the right side (as if you were to field strip it), until the RED painted part showing on the left side of the frame. Remove the slide, then look for one of the legs of the TRS that rests upon the lever. Lift up the leg to clear the notch on the lever, and push the lever to the left until the lever is out. If you don't lift the TRS leg, you will damage it and require a new one.
 
1 - 4 of 4 Posts
Top