[Mattducati]

I am half way through my P30 V2 to V1 LEM conversion.
I was able to successfully install the Light Trigger Return Spring (took some time) but am unsure on how to replace the firing pin block spring.
If anyone could shed some light on how to do this I would greatly appreciate it.

I have searched the forum and have found some pictures, but wanted to ask for guidance on this one as I have not replaced the firing pin block spring before.
If there are any videos or how to threads I would greatly appreciate links to these threads.

Thank you all in advance for your help.

 

[wrt81]

Here you go:

http://www.hkpro.com/forum/hk-reference-library/40627-p2000-sk-uspc-lem-trigger-job-part-1-a.html

It's pretty easy. Sometimes it's a little tricky getting firing pin block to line back up and catch right with the firing pin, but nothing too bad.

 

[TooSixy-closed]

Make sure you tap the FPBS roll-pin from inside out to prevent accidental marring of the slide. A needle-nose pliers will help removing the FPB.
Pay attention to the orientation of the firing pin before removing it. This will help when you insert it back in.

 

[Mattducati]

Thanks wrt81 and TooSixy. Ill give it a try tomorrow afternoon. Thanks again

 

[Bobo]

What parts are needed to go from V1 to V2?

Sorry for the zombie thread, but couldn't find the v1 to v2 p30 info in my search. Thanks.

 

[TooSixy-closed]

Look in the Reference Library.

 

[Bobo]

Look in the Reference Library.

Wow. Too easy. I didn't notice the reference library.

Found out what I needed in 1 second. Thanks for the help.