HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Greetings! New member fro Maine here! I just picked up a used P30SK-V3 which I believe was a COVID/election panic buy. Zero wear to be found anywhere so it may be unfired😃. Anyways when I’m dry firing the pistol the trigger will fail to reset after six or seven ‘shots’. If I lightly touch the rear of the trigger it will reset. All of this is without racking the slide after each shot. I plan to strip it down, flush the guts with WD-40 and then blow it out with compressed air. It’s as though there is a piece of grit floating around in there. Anyone else experience something like this?
 

·
Registered
Joined
·
167 Posts
If it looks like it hasn’t been fired then what’s to flush out? I have seen some pictures of plastic slivers that crack off.
 

·
Registered
Joined
·
6 Posts
That seems like a lot of dry firing. Maybe till you figure it out I wouldn't keep doing that. It may be making it worse
 
1 - 5 of 5 Posts
Top