HKPRO Forums banner

p30sk v4.1 lem conversion issue

812 Views 5 Replies 3 Participants Last post by  rentz
I finally decided to tackle the conversion from v3 to 4.1 got everything together, the TRS surprisingly was the easiest bit but the flat sear spring removal gave me the most struggles.

not that its done i go to put the slide back on and the darndest thing i had to push down on the slide to asseble it, it almost seems as though the disconnector is too high.

so i figure eh, maybe its a fluke go to test fire and the trigger has no tension i have to push it forward then i can dry fire but there is no reset. ive got to manually push the trigger forward each time.

what could be the culprit here? the TRS spring looks to be oriented properly with the right leg up and to the right of the frame (though the slide release lever moves freely without any tension)

well i found part of the problem, the TRS lower spring was in the front of the trigger not behind, which naturally the trs isnt going in nearly as easy now hah.
1 - 1 of 6 Posts
Might just order the trs tool and wait a week.....
If you buy a cheaper pair of needle nose from the dollar store of similar, you can easily grind them away with a dremel and make your own TRS pliers.
Just dremel a hole the diameter of the TRS about 3/16 from the tip.
You can also search here for the red straw method, using the straw from WD40, attached to each end of the TRS which assists installation of that spring.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.