HKPRO Forums banner
1 - 11 of 11 Posts

·
Premium Member
Joined
·
3,928 Posts
Anyone have this setup on a p30L?
My research says it works. pmm posted that a customer showed them it works.
My recollection is that an RCM barrel was used

I'm expecting threaded barrel tomorrow so I can spin that exact combo together
 

·
Registered
Joined
·
155 Posts
Discussion Starter · #3 ·
My research says it works. pmm posted that a customer showed them it works.
My recollection is that an RCM barrel was used

I'm expecting threaded barrel tomorrow so I can spin that exact combo together
I’m also expecting a factory threaded barrel shortly so I’m curious/excited to find out if this combo works. I’ll stay tuned and let me know how it goes? 👍🏽
 

·
Premium Member
Joined
·
2,593 Posts
While I haven't done HK PMM comps, I've played heavily with them for some Beretta projects and I was unimpressed. The HK ones do indeed LOOK cool for what it's worth...
The compensation was minimal. There was a notable POI shift which can be problematic to someone running fixed irons and is looking for specific POA/POI. Thus, Adj rear sight or RDS is the way to fly with comps.
In my case, I needed additional shim kits to time it properly. And even with the torqueing and thread locker, there was finish wear suggesting contact between the comp and frame.

IMHO, comps are a game of give and take. Some are worth it; most aren't. I've not seen where the PMM's were worth it...(again, in my opinion)
 

·
Registered
Joined
·
155 Posts
Discussion Starter · #6 ·
While I haven't done HK PMM comps, I've played heavily with them for some Beretta projects and I was unimpressed. The HK ones do indeed LOOK cool for what it's worth...
The compensation was minimal. There was a notable POI shift which can be problematic to someone running fixed irons and is looking for specific POA/POI. Thus, Adj rear sight or RDS is the way to fly with comps.
In my case, I needed additional shim kits to time it properly. And even with the torqueing and thread locker, there was finish wear suggesting contact between the comp and frame.

IMHO, comps are a game of give and take. Some are worth it; most aren't. I've not seen where the PMM's were worth it...(again, in my opinion)
Appreciate your input. I'm definitely going to do more research before going this route.
Yep. It works.

How does it shoot in your opinion and which shims were used?
 

·
Registered
Joined
·
43 Posts
Appreciate your input. I'm definitely going to do more research before going this route.

How does it shoot in your opinion and which shims were used?
It’s okay. I’ve already removed it. I used the shin pack that came with the comp on a factory HK barrel.
It’s not going to blow your skirt up.
 

·
Registered
Joined
·
155 Posts
Discussion Starter · #9 ·
My research says it works. pmm posted that a customer showed them it works.
My recollection is that an RCM barrel was used

I'm expecting threaded barrel tomorrow so I can spin that exact combo together
Have you taken yours to the range yet? Any updates on what your opinions are on how it shoots?
 
1 - 11 of 11 Posts
Top