HKPRO Forums banner

Problem with C93

6951 Views 16 Replies 12 Participants Last post by  Blitzkrieg
Hi guys I am new to the forum and have a question I recently got a C93 and it runs fine but the problem is that the magazines do not lock in all the way it takes is a bump and the magazines fall out is there any way I can fix it without sending it back to century.
1 - 1 of 1 Posts

· Registered
Joined
·
1,274 Posts
Look at the edges along the magazine well and see where the high spots are with the mag in place. You may notice the raised areas around your mag is the locking point to the magwell and mag catch slot. Do not file the slot. If you file the slot, the mag will fit but it is low in relation to the bolt carrier and ejector. I would file the magwell and try to square it up. During the stamping process, there is probably a small amount of flashing that needs to be cleaned up.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top