HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am researching getting my HK94 refinished. So far I have looked at IGF, ARS, and RDTS. I have read all of the posts on this forum regarding refinishing that I can find and it seems that most folks that have gone with any of these are happy.

I guess right now I am leaning towards ARS strictly because they are the official refinisher for HK. Is there anything else I should be looking at or am missing?
 

·
Registered
Joined
·
670 Posts
Any one of the smiths you have listed do a fine job of refinishing. One thing you might want to do when making your decision is to check with each one about their turn around time as that is the only thing that sets them apart in most cases.

Another one you did not list but IMHO is worth mentioning is Mike at www.tscmachine.com.
 

·
Registered
Joined
·
68 Posts
Both RDTS and IGF use HK black and the finish looks factory.
As csbrit007 said: the biggest thing is turn around time.

RDTS is a little more expensive but you get it back a bit faster.
IGF has a bigger backlog but Jayson could finish your order months early.

Both do an execptional build.
 
1 - 5 of 5 Posts
Top