HKPRO Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I want to use the light hammer return spring and light firing pin block spring in my P2000 SK LEM. I also want to use a 12lb hammer spring. The P30 apparently uses a 12 lb hammer spring, but I don't think it will work in the SK model. Does anybody know who makes a quality 12 lb hammer spring for the SK model?
 

·
Registered
Joined
·
393 Posts
You would have to compare part #'s but I would think the P2000sk hammer spring from a V3 DA/SA version would be lighter than the stock LEM version. That is typically how it is.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
Thanks, I was wondering if that was the case. hkparts.net only list one hammer spring (HKP-2598) on their site for the P2000 SK and they don't differentiate between DA/SA, or LEM. I will call tomorrow and ask.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
You would have to compare part #'s but I would think the P2000sk hammer spring from a V3 DA/SA version would be lighter than the stock LEM version. That is typically how it is.
I called HKparts.net and they only list one hammer spring for both versions of the P2000 SK. It looks like the V1 DA/SA and V2 LEM use the same hammer spring.
 

·
Registered
Joined
·
108 Posts
Realizing this thread is several months+ old....

What can I do to lighten the DA trigger pull on my P2000sk?
Possibly shorten the USP Match hammer spring to the (SK) length...

Ideas?

Thx S1
 
1 - 6 of 6 Posts
Top