HKPRO Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I would appreciate some constructive feedback as to how you go about leveling up a B&T scope mount. I have removed the rear sight on my PTR 91 and
used a machinist level to set the rifle into a proper level position. I have tried and tried to get this B&T 21174 low mount square and level in relation to the rifle. I have the mount about 1/4 bubble off level compared to the rifle. Any suggestions or is this amount of tolerance acceptable? Any help would be greatly appreciated !!
 

·
H&K Certified Armorer
Joined
·
8,216 Posts
Check and make sure you have the proper locking blocks on the correct sides. The left side of the mount should have the angled blocks and the right side should have the squared ones... to coincide with the geometry of the cuts on the tabs.
 
1 - 2 of 2 Posts
Top