HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
232 Posts
Discussion Starter #1
I've got a new 10-8 sight on the way for my 45c. The question I have is, do I need a sight adjustment tool and does it drift out left to right or right to left? Where's the best place to pick up a sight pusher, if I need one? Thanks Much
 

·
Registered
Joined
·
393 Posts
The direction you drift it out doesn't matter. As far as a pusher, I use a vice, some rubber padding, a brass punch, and a hammer. But, MGW (I think) does sell a pusher for the P2000/USPc series that I believe I have heard works fine with the P30 as well. I do know that Heinie sights don't work with the pusher because they are too tall, not sure if that would be an issue with the 10-8 sight.
 

·
Registered
Joined
·
276 Posts
Check out eBay, search for....JMT sight pusher tool. Only $60! I have seen guys recommend them. It won't win any beauty contests, either will a vise, brass punch and hammer! (what I use) Either way they both get the job done!
 
1 - 3 of 3 Posts
Top