HKPRO Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
So after a month and a half of doing research, I finally put a HK91 stock on Layaway. Now from what I can understand, this should be quite a simple modification to do to get this stock to fit my C93. The entire gun works fantastic, so I want to put the awesome looking and functional collapsible stock on it.

So the steps that I have to do this in is as follows:

1.) Get the stock and get a dremel

2.) Cut off the front pin hole and make it match the C93.

3.) Remove the recoil rod that was for the HK91

4.) install, and done

is that right? I dont want to screw this up.

Should there be any other instructions that I am neglecting, or anything im missing at all? Being a broke college student, I get one shot at making this perfect.
 

·
Registered
Joined
·
536 Posts
Yea, you are not thinking about the fact the 91 stock is made for a longer receiver then your 93. The stock will not fully collapse.
 

·
H&K Certified Armorer
Joined
·
8,213 Posts
93 has a single push pin hole. 91 has dual.
 

·
Registered
Joined
·
18 Posts
Discussion Starter #5
Yes, it is longer, so I'll just cut down the stock bars enough to let it lock. Other than that, and taking out the recoil rod and the second push pin hole, thats it?
 

·
H&K Certified Armorer
Joined
·
8,213 Posts
Yes, it is longer, so I'll just cut down the stock bars enough to let it lock. Other than that, and taking out the recoil rod and the second push pin hole, thats it?
You'll may need to install a "cup" where you removed the recoil rod.
 
1 - 6 of 6 Posts
Top