HKPRO Forums banner

Stupid CAN be fixed - failure to feed on 40Expert

1814 Views 14 Replies 7 Participants Last post by  svtpwnz
I was thinking about something else when I loaded 9mm rounds into my 40 Expert. Shot a couple before I realized what was going on. Since then I have had a recurring problem with the last round in the magazine failing to go into battery. I tried cleaning thoroughly including the extractor and this has not solved the problem. It is otherwise functioning normally up to that last round. Did I break something? Time for a visit to the gunsmith?
1 - 1 of 15 Posts
Do you push the pin from the inside of the slide out through the top?
Yes, to prevent accidental marring of the slide. Use a 3/32 roll-pin punch. The extractor roll-pin is the one circled in Red in below pic.

See less See more
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.