HKPRO Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I purchased a PTR C93 via online auction. When I received it, I realized the trigger housing is not the same as I have seen on other C93 or PTR93s. What is going on here? And what will happen when I set it to "F"? 8|

Thanks
 

Attachments

·
Registered
Joined
·
2,252 Posts
It will shoot full auto......be aware!
 

·
Registered
Joined
·
2,252 Posts
Just messing with ya, I'm sure it's just a converted housing. If you want to be safe, pull the trigger pack and post a photo of it, or you can PM me a photo.

Many people use military trigger housings to give it that authentic look and usually they're more ergonomic.
 

·
Registered
Joined
·
99 Posts
Make sure unloaded and no ammo around. Put in f. Charge the weapon and let bolt go forward. Pull trigger hear a click and hammer fall. Keep trigger back charge the weapon again and let bolt slice forward. If the hammer falls forward this time go straight to jail unless you have it stamped. If not let go of the trigger and pull again hammer should fall. You are good to go.
 

·
Registered
Joined
·
210 Posts
Most likely a clipped pinned lower very comon take lower off see if the push pin is cut and glued in everyone is doing it to get that look.
 
1 - 5 of 5 Posts
Top