HKPRO Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter · #1 ·
I was wondering what the quality of the TN USC sear and stock (without their plastic stock block) is. I was looking at their website and the stock seems to be a less expensive 922r part than the HDPS trigger. My only concern is if a significant amount of modification is needed to get the stock to fit in the HDPS stock block. Any input would be greatly appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top