HKPRO Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
518 Posts
Discussion Starter #1
I know this is going to sound very anal...but my UMP mags seem to be pretty loose in my UMP conversion mag well. They wiggle from side to side quite a bit and a was wondering if this is normal, or if you guy's conversions are pretty solid.

Thanks for any input!

-Mike
 

·
Registered
Joined
·
731 Posts
My .45 mags move a VERY VERY little bit, I'll check my 9mm later but I'm sure they are just as tight.
 

·
Registered
Joined
·
34 Posts
I know this is going to sound very anal...but my UMP mags seem to be pretty loose in my UMP conversion mag well. They wiggle from side to side quite a bit and a was wondering if this is normal, or if you guy's conversions are pretty solid.

Thanks for any input!

-Mike
who did your work?
 

·
Registered
Joined
·
518 Posts
Discussion Starter #4 (Edited)
HDPS. I don't want to sound like I'm complaining...Cause Ed did a fantastic job...I'm wondering if too much material was removed from the upper receiver though.

It looks like the material removed to make room for the magazine is taken to within about millimeter or 2 of the receiver wall on both sides...Does this plastic help told the magazine solid?
 
1 - 7 of 7 Posts
Top