HKPRO Forums banner

USC barrel swap

1213 Views 4 Replies 4 Participants Last post by  57madness
Just got a USC from Bud's. Looking to go the SBR route, and I was wondering if swapping the barrel is something I can do, or if I need to send it off to have it done (after the paperwork). I have a new barrel on the way, and want to get a plan in place to swap it.

1 - 5 of 5 Posts
Super easy, requires a hammer and punch and about 30 seconds of your time (once you have your approved from 1 in hand of course).
I literally lay it across my lap when knocking out the barrel pin. On ones that have been fired a lot, it sometimes takes knocking the barrel itself out with a hammer and wood block, and back in with a long wooden dowel.
as always, you guys got me the info.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.