HKPRO Forums banner

Used USPc Inspection

576 Views 1 Reply 1 Participant Last post by  Thrux86
Going to be picking up a used USPc in 9mm tomorrow. This will be my first firearm. Is there anything I should be looking for that is non-obvious while inspecting it? Thanks for the help!
1 - 2 of 2 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #2 ·
Well, no need! Went to go check it out and fill out paperwork, as it had arrived. Looked barely fired! Not a mark on the stainless at all. Only downer is it doesn't have that 13rd mag, just the 10rd. I pick it up Friday and taking it to the range Saturday.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top