[tb1358]

I apologize for having to ask for clarification, after there has been so much posted on this topic. I've seen information for the full size USP & for the SK - however, I did not detect anythig specific to the compact USP.

Will you please help me with the exact parts need to reduce the trigger pull to 4.5 - 5.0 #. Also, the best place to attain these parts.

Again I apologize but need your help

Thank you

 

[Desertrider]

I posted this yesterday

The USP/C parts numbers listed in the link below. e-gunparts.com have them in stock... though they use different stock numbers. Just have them cross reference.

http://www.hk-usa.com/wforum/viewtopic.php?t=947&highlight=spring+change

http://hkpro.com/forum/showthread.php?t=40627&page=23&highlight=lem+trigger

 

[bspring]

Short of a trigger job, removing 2 coils off the hammer spring will help. A few parts from a match kit will help but at $120 for the match kit it gets expensive.

Bill

 

[tb1358]

e-gunparts sales rep did not have a conversion part for the trigger return spring 209266 - any ideas OR do any of you have the egunpart # , due to already woking thru this challenge?

 

[tb1358]

UPDATE

UPDATE:

I just got off the phone with E-Gun. Their part numbers X referenced against H&K we as follows, to to lighten the trigger pull, on the USP/C LEM.

E-GUN.COM PART NUMBERS

FIRING PIN BLOCK SPRING: 1041920

TRIGGER REBOUND SPRING: 603360

** Parts are in stock

For reference, the HK part numbers are:

FIRING PIN BLOCK SPRING: 209296 (after 2005) - my gun is an AG date code

TRIGGER REBOUND SPRING: 209266